Skip to main content

EOL and alerts

Part statuses​

Every part with an EOL configured moves through five statuses as it accrues life:

StatusMeaning
FreshEarly in its life.
Mid-lifePast half of the warning threshold.
WarningPast the Warn % of its category (default 75%).
CriticalPast the Critical % (default 90%).
Over limitAt or past 100% of its (effective) EOL.

Parts whose category has no EOL show grey ("No EOL") — not a false "fresh". With multi-unit lifing, the status shown is the worst dimension (km, hours, events or expiry) — whichever cycle ends first drives the alert.

The part detail panel​

Click any part to open its panel. You'll find:

  • Mileage bar and % used — how much of its life it has consumed (respecting Target use %).
  • History + projection chart — accumulated km per event, the EOL line, and a projection over upcoming events estimating at which event it will hit EOL.
  • EOL forecast — remaining km and events until EOL, with a heads-up when replacement is due soon.
  • Per-event breakdown — km added at each event.
  • Measurements / Notes / Rebuilds — measurement history, inspection notes, rebuild log.
  • Label tab — printable QR label, also as SVG for laser engraving.

All these figures are consistent with each other and with every list (Parts, Cars, Dashboard) — they come from a single calculation engine.

Where to see wear at a glance​

  • Dashboard — the "Ready for …?" card, project KPIs, parts near EOL, total km and km by category.
  • Parts — every part with its EOL bar; filter by category; see retired parts.
  • Fleet — per-car view: total km and per-car alerts.

Ready for the next event?​

The first card on the Dashboard answers one question per car: can it run at the next event on your calendar? Each car gets one verdict:

  • Not ready — something stops it: a part already over its limit, a part due to pass its limit during that event, a part or car document that expires before the event ends, or an open major chassis finding.
  • Check first — nothing is over its limit, but something can't be confirmed yet. Examples: a ledger that didn't load, a part with no expiry date, an inspection flag, or a part in its critical band with no laps to project from.
  • Checking… — the mileage, hours, swap or chassis records are still loading.
  • No limits set — the car has no parts fitted, or none of them has a life limit, so there is nothing to check.
  • Ready — every fitted part with a limit has life left for that event, and nothing above applies. The tile also names the most-worn part, so you can see the margin.

Each reason carries its numbers (for example "needs ~520 km at Aragón, has 412 km left"). Tap a reason to open the part. Expiry is checked against the event's last day: a harness that is valid today but lapses before Sunday's race is Not ready for that event.

The card uses the same calculation as Operational alerts and each car's Alarms tab, so they never disagree. The alerts list below it can look 1 to 3 events ahead.

You're done with setup​

From here, ICRX runs itself: log laps, complete sessions, and act on the alerts. Next stops:

Was this page helpful?